-
- Trade Leads
- Trade Services
- B2B Directories
- Trade Connections
- Misc
- Contact Us
A free import export trade leads B2B marketplace since 1996 for manufacturers, suppliers, exporters, importers, buyers, sellers, wholesalers, freight forwarders, shippers, trade shows, exhibits, and export management.
Hello visitor from
USA - 41 visiting from 38 USA 
2 UK 
1 Belgium
Hello visitor from
USA - 41 visiting from 38 USA 2 UK 1 Belgium
Knowledge Of Accident Prevention For Palm Oil Tanker
Posted at: Offers to Sell and Export | Posted on: Tuesday 26 May 2020 1:57 am | Poster last visit: Friday 15 September 2023 | Targeted Countries: Bangladesh | Gambia | Tonga
Product Category: Main
» Commercial and Military and Private Vehicles and their Accessories and Components
» Vehicle bodies and trailers
» Product and material trailers
» Trailer and semi trailer parts
» Knowledge Of Accident Prevention For Palm Oil Tanker
Product Description:
First of all, the oil loading equipment does not meet the specifications, equipment failure, oil leakage,
electrostatic discharge and human misuse are the main reasons for the fuel tanker fire. According to the experience and lessons, the following aspects should be taken into consideration to ensure the safety of oil filling in aluminum tanker trailers.
1. Prevent static electricity hazards
Static grounding cannot be ignored. From the perspective of diesel fuel tanker trailer, the main parts of static electricity are pumps, filters and pipes. The static electricity generated by the tanker filling system is much higher than that of the ground pipeline. Relevant information reflects: If a 250m long and 100mm diameter underground pipe is used to pump oil at a flow rate of 2500L / min, the charge from the fuel gun is generally only a few degrees, but after passing through the tanker, the charge is exceeded. These Static electricity is mainly generated by the filter of the tank truck, so if the tank truck is not grounded and the loading and unloading operation is carried out, the tank body can carry a voltage of more than 10kV;
TITAN stainless steel tanker trailer for sale
Therefore, for the hidden danger of static electricity, the following measures must be taken:
① Connect the ground wire before filling the oil, and often check its intact condition. We also need to pay attention to whether the grounding resistance meets the anti-static standard.
②The crane pipe must reach the bottom of the petrol tanker trailer when filling oil, the pipe mouth should be kept at about 15cm from the bottom of the tank, and the initial filling speed should be strictly controlled within 1m/s, until the oil outlet is submerged, then gradually increase the flow rate, but The maximum flow velocity should not exceed 4.5m / s to prevent electrostatic accidents caused by spraying;
③After the oil filling is completed, the ground must be disconnected after 5 minutes of oil stabilization. Because after the oil is installed, the oil surface potential will remain for several minutes because the oil flows in the tank.
2. Strictly abide by the operating regulations
Don't relax your vigilance because of good grounding. Electrostatic grounding can only conduct static electricity on "conductors" (metals, human bodies, conductive liquids, etc.) that are closely connected to it. Static charge is helpless or difficult to remove in a short time;
Therefore, while electrostatically grounding, the operator should strictly follow the operating procedures and pay attention to the hidden dangers that may arise at any time, and at the same time master the emergency methods and rescue measures for correctly handling various emergencies.
3. Pay attention to the details of wearing clothing
Prevent people from being charged. During loading and unloading operations, the human body must be in contact with work objects and work objects to produce friction, which is very easy to generate static electricity and may form electrostatic discharge.
An explosion will occur. The operator must wear anti-static work clothes and anti-static shoes during the operation, the purpose of which is to ground the human body. In addition, the shoes worn should be thin nylon socks or other conductive socks. It is strictly prohibited to paste insulating film on the antistatic soles, and regular inspections should be made.
4. Regular inspection of safety equipment
Equipment that meets technical specifications and safety requirements must be used. The automatic control, remote control, measuring instruments, valves and other equipment of the oil delivery station must be regularly inspected and calibrated, and related management systems should be formulated, especially the material of the oil delivery equipment cannot be underestimated. It is strictly forbidden to use non-conductive polyethylene hoses as oil pipelines for oil delivery crane pipes, and it is strictly forbidden to use plastic containers when handling oil products. The above are the most basic safety common sense
At the same time, the static grounding device can not be made up, and it is necessary to strictly follow the specifications, install it carefully, and check it regularly. For the current commonly used clamps and magnetic joints to be grounded, they should not be randomly clamped or adsorbed on any part of the diesel tanker trailer for sale, even on the painted surface. This is extremely detrimental to anti-static, but also a big hidden danger.
Company Contact:
Contact Name: Vehicle Titan
Company Name: Titan Vehicle
Email:
Tel: 18615201302
Fax:
Street Address: Jinan
Shandong Jinan, Shandong 250000
China
Website: https://www.titanvehicle.com/
Member name: TitanVehicle
Country:
China
Member Since: 25 March 2020
Total Leads: 121 TitanVehicle Import Export Business Leads
Business focus: Truck, Trailer, Semi Trailer, Flatbed Semi Trailer, Lowbed Trailer, Sidelifter, Fuel Tanker Trailer, Cement Bulker, Tipper Semi Trailer
Chat:
Verify: Safe Import Export Tips
electrostatic discharge and human misuse are the main reasons for the fuel tanker fire. According to the experience and lessons, the following aspects should be taken into consideration to ensure the safety of oil filling in aluminum tanker trailers.
1. Prevent static electricity hazards
Static grounding cannot be ignored. From the perspective of diesel fuel tanker trailer, the main parts of static electricity are pumps, filters and pipes. The static electricity generated by the tanker filling system is much higher than that of the ground pipeline. Relevant information reflects: If a 250m long and 100mm diameter underground pipe is used to pump oil at a flow rate of 2500L / min, the charge from the fuel gun is generally only a few degrees, but after passing through the tanker, the charge is exceeded. These Static electricity is mainly generated by the filter of the tank truck, so if the tank truck is not grounded and the loading and unloading operation is carried out, the tank body can carry a voltage of more than 10kV;
TITAN stainless steel tanker trailer for sale
Therefore, for the hidden danger of static electricity, the following measures must be taken:
① Connect the ground wire before filling the oil, and often check its intact condition. We also need to pay attention to whether the grounding resistance meets the anti-static standard.
②The crane pipe must reach the bottom of the petrol tanker trailer when filling oil, the pipe mouth should be kept at about 15cm from the bottom of the tank, and the initial filling speed should be strictly controlled within 1m/s, until the oil outlet is submerged, then gradually increase the flow rate, but The maximum flow velocity should not exceed 4.5m / s to prevent electrostatic accidents caused by spraying;
③After the oil filling is completed, the ground must be disconnected after 5 minutes of oil stabilization. Because after the oil is installed, the oil surface potential will remain for several minutes because the oil flows in the tank.
2. Strictly abide by the operating regulations
Don't relax your vigilance because of good grounding. Electrostatic grounding can only conduct static electricity on "conductors" (metals, human bodies, conductive liquids, etc.) that are closely connected to it. Static charge is helpless or difficult to remove in a short time;
Therefore, while electrostatically grounding, the operator should strictly follow the operating procedures and pay attention to the hidden dangers that may arise at any time, and at the same time master the emergency methods and rescue measures for correctly handling various emergencies.
3. Pay attention to the details of wearing clothing
Prevent people from being charged. During loading and unloading operations, the human body must be in contact with work objects and work objects to produce friction, which is very easy to generate static electricity and may form electrostatic discharge.
An explosion will occur. The operator must wear anti-static work clothes and anti-static shoes during the operation, the purpose of which is to ground the human body. In addition, the shoes worn should be thin nylon socks or other conductive socks. It is strictly prohibited to paste insulating film on the antistatic soles, and regular inspections should be made.
4. Regular inspection of safety equipment
Equipment that meets technical specifications and safety requirements must be used. The automatic control, remote control, measuring instruments, valves and other equipment of the oil delivery station must be regularly inspected and calibrated, and related management systems should be formulated, especially the material of the oil delivery equipment cannot be underestimated. It is strictly forbidden to use non-conductive polyethylene hoses as oil pipelines for oil delivery crane pipes, and it is strictly forbidden to use plastic containers when handling oil products. The above are the most basic safety common sense
At the same time, the static grounding device can not be made up, and it is necessary to strictly follow the specifications, install it carefully, and check it regularly. For the current commonly used clamps and magnetic joints to be grounded, they should not be randomly clamped or adsorbed on any part of the diesel tanker trailer for sale, even on the painted surface. This is extremely detrimental to anti-static, but also a big hidden danger.
Company Contact:
Contact Name: Vehicle Titan
Company Name: Titan Vehicle
Email:
Tel: 18615201302
Fax:
Street Address: Jinan
Shandong Jinan, Shandong 250000
China
Website: https://www.titanvehicle.com/
Member name: TitanVehicle
Country:
ChinaMember Since: 25 March 2020
Total Leads: 121 TitanVehicle Import Export Business Leads
Business focus: Truck, Trailer, Semi Trailer, Flatbed Semi Trailer, Lowbed Trailer, Sidelifter, Fuel Tanker Trailer, Cement Bulker, Tipper Semi Trailer
Chat:
Verify: Safe Import Export Tips
Similar Suppliers And Manufacturers Import Export Trade Leads
Decanter Centrifuge Palm Oil Processing Machine - By Dagyee - On Friday 14 October 2022 7:38 am: decanter centrifuge palm oil processing machine
the machine starts and speeds up automatically when the proper working condition are met and the revolving drum reaches the feeding speed the feedi....
Wicker Palm Leaf Woven Basket Lined With Checkered Fabric Made In Vietnam Hp B068 - By handipassion - On Monday 3 July 2023 3:49 pm: palm leaf woven basket lined with checkered fabric made in vietnam hp - b068
details
size customized
amp #8203
color natural or customized
m....
Oil Drill Rig Use Rotor Bearing 535550 Zlp5 With Oil Hole - By jinshuobearing - On Tuesday 1 August 2023 1:35 pm: oil drill rig use rotor bearing 535550 zlp5 with oil hole
the bearing 535550 belongs to large bearings that have threaded holes for the location of e....
Ad3e301-02d03v / -w Eh Oil Hydraulic Unit Pressure Switch Inlet Outlet Strainer Oil Filter Wrench - By DongfangYoyik - On Thursday 14 July 2022 12:52 am: oil hydraulic unit pressure switch inlet outlet strainer oil filter wrench for turbine generator parts
is to use the generator sets of professional p....
Of3-08-3rv-10 Eh Oil System Oil Suction Filter Activated Carbon Filter Cartridge Steam Turbine - By DongfangYoyik - On Wednesday 6 July 2022 3:03 am: oil system oil suction filter activated carbon filter cartridge chinese steam turbine parts
our company is equipped with high-precision cutting-edge ....
Original China Hq25.300.16z The Best Oil Filter Eh Oil System Cellulose Filter For India Power - By DongfangYoyik - On Friday 12 May 2023 12:31 am: oil filter eh oil system cellulose filter for india power station
dongfang yoyik engineering co ltd is a manufacturer and trader of industrial prod....
China Supply Rlfdw / Hc1300cas50v02 Duplex Lube Oil Filter Hp Oil Station Filter For North West Powe - By DongfangYoyik - On Friday 12 May 2023 12:33 am: oil filter hp oil station filter for north west power generation
yoyik is a hi-tech company specializing in the production development and sale of s....
Ztj300-00-07 Eh Oil System Flushing Filter Machine Oil Filter Steam Turbine Parts - By DongfangYoyik - On Thursday 14 July 2022 12:54 am: oil system flushing filter machine oil filter steam turbine parts
yoyik is specialized in manufacturing and providing components for turbines coal-f.... Trailer and semi trailer parts Classification Navigation
Main - Commercial and Military and Private Vehicles and their Accessories and Components - Vehicle bodies and trailers - Product and material trailers - Trailer and semi trailer parts [108]
TradersCity.com shall not be held liable for any user posted/submitted content including but not limited to trade leads, profiles, images, and any other data. TradersCity.com does not and did not verify any of users posted/submitted data nor is implicitly or explicitly recommending these business offers. TradersCity does not verify truthfulness, accuracy, completeness, nor legality of any businesses, services, and leads posted here. TradersCity does not represent Sellers or Buyers in any transaction between users of the website and is unable to make any opinion in regard to their performance in any transaction. TradersCity neither guarantees nor undertakes in any dispute between sellers and buyers. Protect your business from fraud by trading safely